Unable to load base Error

[Aaron]

Hello,

Did you get a chance to try accessing it via \\network\ path and \\ipaddress\ instead of bound Drive Letter s:?

Drive letter mapping is not as consistent; your particular setup may have a script that triggers and binds the drive letters during boot up (where, a reboot would then help by re-triggering this if the initial binding didn't work.) When you find that the S: does not connect in script, are you able to browse it with My Computer or Windows Explorer before rebooting?

[msgBldr]

Sorry, it only seems to happen when I add a new drive. I'll try it if it happens again. NetworkDriveManager reconnects about every ten minutes or so, would seem to take care of it but...

"When you find that the S: does not connect in script, are you able to browse it with My Computer or Windows Explorer before rebooting?"

Yes. Not only that, I can run BC3 with that drive with no problems.

Thanks... Bob