Hello,
1) Thank you for reading this post.
2) I installed this on RHEL 6.1. I know 6 is supported is 6.1 as well?
3) If it is supported is there a way to verify it installed properly? Below is the install dialog from RPM. The system admin did not use YUM. I was surprised that it did not complain about dependencies.
4) What is the default install location?
5) How to I invoke beyond compare on linux from the command line.
================================================== =======
[root@eglwlnvm401 tmp]# rpm -ivh bcompare-3.3.8.16340.i386.rpm
warning: bcompare-3.3.8.16340.i386.rpm: Header V3 DSA/SHA1 Signature, key ID 7f8840ce: NOKEY
Preparing... ########################################### [100%]
1:bcompare ########################################### [100%]
[root@eglwlnvm401 tmp]#
================================================== =======
Thanks,
Ted
1) Thank you for reading this post.
2) I installed this on RHEL 6.1. I know 6 is supported is 6.1 as well?
3) If it is supported is there a way to verify it installed properly? Below is the install dialog from RPM. The system admin did not use YUM. I was surprised that it did not complain about dependencies.
4) What is the default install location?
5) How to I invoke beyond compare on linux from the command line.
================================================== =======
[root@eglwlnvm401 tmp]# rpm -ivh bcompare-3.3.8.16340.i386.rpm
warning: bcompare-3.3.8.16340.i386.rpm: Header V3 DSA/SHA1 Signature, key ID 7f8840ce: NOKEY
Preparing... ########################################### [100%]
1:bcompare ########################################### [100%]
[root@eglwlnvm401 tmp]#
================================================== =======
Thanks,
Ted
Comment