Announcement

Collapse
No announcement yet.

Cannot configure automatic check out with Visual SourceSafe

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cannot configure automatic check out with Visual SourceSafe

    Hi everyone.
    I'm trying to configure automatic check out with Visual SourceSafe 2005.
    I did it successfully with BC3, but I have installed version no. 4 a few days ago and haven't had any luck in doing it there.
    Following the instructions in http://www.scootersoftware.com/support.php?zz=kb_scc, I enter the local folder corresponding to the root of my SCC repository in the "path to the new association" , but I get the error "No providers detected".
    My OS is Windows 10 (installed today! ), and the SCC repository path is in a network drive. Checking out & in from the SCC GUI works as usual

    Thank you

  • Piddu
    replied
    That was it! Thank you again Aaron

    Leave a comment:


  • Aaron
    replied
    Hello,

    Yes, although with a Portable Install, the installer wizard will prompt if you want 32bit or 64bit. You do not need the /32 flag; just run the setup.exe and select to create another Portable Install, then select 32bit and the install location to create a new 32bit Portable.

    Leave a comment:


  • Piddu
    replied
    Hello Aaron,
    thank you.
    I'm using a portable install now. Do I have to run the setup?

    Leave a comment:


  • Aaron
    replied
    Hello,

    The solution is to run our setup.exe with the /32 argument. This will force a 32bit install, which should match BC3 behavior. Visual Source Safe is a older 32bit application and does not support 64bit source control integration.

    Leave a comment:

Working...
X