Comparing/Merging XML files is something that I do on an almost daily basis. What's the best way to set this up under BC3? I'd prefer if there was a pre-processor that would "pretty-print" the XML files before comparison in order to rule out that type of differences.
Under BC2, I think there were 2 ways to handle this, I think there was a built-in method, and then another method that used an external conversion tool (maybe xml tidy).
What's the preferred way of doing this under BC3? Will XML formatting be built into the final version, or should I go ahead and setup XML Tidy, or some other external conversion?
Thanks,
Rob
Under BC2, I think there were 2 ways to handle this, I think there was a built-in method, and then another method that used an external conversion tool (maybe xml tidy).
What's the preferred way of doing this under BC3? Will XML formatting be built into the final version, or should I go ahead and setup XML Tidy, or some other external conversion?
Thanks,
Rob
Comment