Announcement

Collapse
No announcement yet.

Unable to load base Error

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Hello,

    Did you get a chance to try accessing it via \\network\ path and \\ipaddress\ instead of bound Drive Letter s:?

    Drive letter mapping is not as consistent; your particular setup may have a script that triggers and binds the drive letters during boot up (where, a reboot would then help by re-triggering this if the initial binding didn't work.) When you find that the S: does not connect in script, are you able to browse it with My Computer or Windows Explorer before rebooting?
    Aaron P Scooter Software

    Comment


    • #17
      Sorry, it only seems to happen when I add a new drive. I'll try it if it happens again. NetworkDriveManager reconnects about every ten minutes or so, would seem to take care of it but...

      "When you find that the S: does not connect in script, are you able to browse it with My Computer or Windows Explorer before rebooting?"

      Yes. Not only that, I can run BC3 with that drive with no problems.

      Thanks... Bob

      Comment

      Working...
      X